EOPX - Modul configuration

On this page you can configure modules based on the Dolphin platform. Using this page you can enter values which will be saved in the configuration area u8ReservedAPP range. For more information read the DolphinAPI Manual chapter Dolphin Platform\Flash architecture .




How to use:
  1. Select the module you would like to configure.
  2. Press the read configuration button to get the actual configuration from the module.
  3. Configure settings for the module.
  4. Write the configuration to the module.

TIP: Using Merge CFG To... you can save the current settings to existing _cfg file. This is handy when preparing .hex files for the production.

Example:
For STM300 firmware we have following files:
  STM300-868.hex
  STM300-868_cfg.hex

After adjusting the STM300 setting in Module Configurator click on Merge CFG To... and select the STM300-868_cfg.hex.
The STM300 settings are then mergen into STM300-868_cfg.hex. This file can be then used for the production.

Note: This page converts the data from the combo boxes to hex values and writes them to the CFG area application range.