Does TCM310 have a teach-in function? This article applies to:DolphinAPI QUESTION Does TCM310 have a teach-in function? ANSWER No, as a gateway is has no teach-in. But if all you need to do is to filter out certain kinds of messages, you can use the filter command of ESP3. This can be done in the following […] Read More
WAKE pins do not work on EVA300 and TCM300/TCM320 This article applies to:EVA300, TCM300, TCM320 QUESTION I wrote a custom firmware on TCM300 but I am unable to wake the module using the WAKE pins on the EVA board. What am I doing wrong? ANSWER The WAKE pins and several other pins are not available on TCM300/TCM320 […] Read More
Problem when receiving telegrams from TCM300 through the serial port using EVA300 This article applies to:TCM300/TCM300C Module QUESTION I cannot receive any telegram through the serial port. I also cannot see any information with Winetel/DolphinView 2.0.0.0. ANSWER Make sure the ID table is cleared (press the CLR button for 3 seconds) Make sure the Mode0/1 is […] Read More
How can I use the flywheel timer? This article applies to:STM300 QUESTION I need a very precise timer for synchronous networks. I heard I could use the flywheel timer for this purpose. How to do it? ANSWER To use the flywheel Timer you will need a Wrist Watch Christal, we recommend the CM200CIn order to evaluate the […] Read More
STM300 sends no telegram when pressing WAKE0/LRN button This article applies to:STM300 QUESTION I am using STM300 module with EVA320. I have just unpacked this module put to the EVA board. I am using the default firmware and haven’t changed anything. When I press the WAKE0/LEARN button nothing happens. When I press WAKE1 button I see telegrams, why? […] Read More
PID and VID of EnOcean USB 300 – FTDI Chip configuration This article applies to:All EnOcean devices with FTDI chip QUESTION How I can change USB specific values (e.g. PID/VID) of the USB 300?How can I recognize an EnOcean Module connected to the host (e.g. PC)? ANSWER EnOcean is using FTDI’s FT232 chip within USB 300. Since […] Read More
Smart Acknowledge Learn Modes This article applies to:Smart AcknowledgeDolphinAPI Version: 2.2.3.0 and later QUESTION What are the Learn Modes of Smart Acknowledge and how should I use them? ANSWER Smart Acknowledge has 3 Learn modes: Simple Mode – Learn Sensors only with direct radio contact to controller. Use this mode when you do not want to enable […] Read More
How to integrate EnOcean USB 300 / Programmer with host controllers. This article applies to: All Enocean Dolphin based devices with with FTDI chip QUESTION How can I use USB 300 / Programmer with Microsoft Windows? How can I use USB 300 / Programmer with Linux? ANSWER USB 300 and EnOcean Programmer (EOP) have both and FTDI Chip […] Read More
No FTDI Drivers Found This article applies to:DolphinView, DolphinStudio QUESTION I have installed DolphinView or DolphinStudio. I have selected the checkbox to install or update FTDI drivers during installation. Still after plugging in the EnOcean Programmer I get a Driver messagebox (see picture below) that the drivers where not found. What to do now? German English […] Read More
